1 MHz GBW, 1V/µs slew — signal chain fit
The LMV358M-NS is a dual general-purpose op-amp from the LMV358 family, delivering a 1 MHz gain-bandwidth product and a 1V/µs slew rate. That slew rate limits the full-power bandwidth to roughly 160 kHz at a 1 V peak output swing — fine for sensor conditioning, audio line-level signals, or ADC driver stages where you don't need fast pulse fidelity.
190 µA per channel — battery-conscious bias
Each amplifier draws 190 µA of supply current, totalling 380 µA for both channels. In a battery-powered sensor node or portable instrument that stays on continuously, that quiescent current is low enough to keep the power budget under control without resorting to a micropower op-amp that sacrifices bandwidth. Input bias current is 15 nA typical, so you won't see significant offset drift from high-source-impedance sensors like pH probes or thermistors.
Input offset voltage is specified at 1.7 mV — adequate for general-purpose signal conditioning but not precision; if you need sub-millivolt offset, look at a zero-drift amplifier in the same package.
Package and footprint
Surface-mount only; no through-hole variant. The supplier device package is 8-MSOP, so the PCB land pattern matches the standard MSOP-8. Note that the listing shows the shipping medium as Bulk (tubes or loose parts), not Tape & Reel — factor that into your pick-and-place setup if you're ordering for high-volume assembly.