15 MHz GBW, 0.2 pA input bias — precision front-end for sensor and signal conditioning
The LMP7707MA/NOPB is a single-supply, rail-to-rail output op-amp from the LMP® PowerWise® series. Its 15 MHz gain-bandwidth product and 5.9 V/µs slew rate cover moderate-speed precision amplification — think strain-gauge bridge amplifiers, thermocouple linearization, and photodiode transimpedance stages where both bandwidth and DC accuracy matter. Input bias current is 0.2 pA typical, and input offset voltage is 37 µV — the combination lets you interface directly to high-impedance sensors (pH probes, pyroelectric detectors) without a separate buffer stage eating into the noise budget.
Single-supply 2.7–12 V rail with rail-to-rail output
Supply span runs from 2.7 V to 12 V, so the same BOM position works on a 3.3 V ADC driver or a 5 V industrial loop. The rail-to-rail output stage swings within millivolts of the rails, preserving dynamic range when the supply is tight. Quiescent current is 790 µA per amplifier — modest enough for multi-channel data-acquisition systems running 8–16 channels on a shared 24 V backplane, but not an ultra-low-power part for battery duty. Output can source or sink 86 mA, enough to drive a 100-ohm load to within 1 V of the rails. That same headroom matters when the op-amp must charge the sampling capacitor of a SAR ADC through the anti-aliasing filter.
Industrial temperature range, active lifecycle
Rated for -40°C to 125°C — the full industrial and extended-industrial junction temperature band. An outdoor telemetry node or an engine-bay sensor interface meets the temperature requirement without derating. Product status is Active per Texas Instruments. Long-term support for production builds is stable through authorized and independent channels. RoHS3 compliant. The 8-SOIC (0.154", 3.90 mm width) package is a standard footprint shared across hundreds of TI op-amps — PCB layout reuse is straightforward.