Skip to main content
LM358DR-JF
Texas Instruments

LM358DR-JF Texas Instruments Dual Op-Amp, 700 kHz GBW

MPNLM358DR-JF
Active

Texas Instruments LM358DR-JF, General Purpose Amplifier, Dual Op-Amp, 700 kHz Gain Bandwidth Product, 0.3 V/µs Slew Rate, 3V to 30V Supply, 8-SOIC Package, 0°C to 70°C Operating Temperature.

LM358DR-JF datasheet
StockContact for availability
MOQ1 pcs
  • 100% new & originalTraceable channels only — no refurbs, no pulls, no remarked parts.
  • Date & lot codes on quoteStated per line before you commit; label photos on request.
  • MSL-compliant ESD packingMoisture-sealed bags with indicator cards; reels photo-verified.
  • PayPal buyer protectionPay by T/T, PayPal or Payoneer — card payments covered end to end.

Specifications

LM358DR-JF Technical Specifications
ParameterValue
Mounting typeSurface Mount
Amplifier typeGeneral Purpose
Voltage - input offset3 mV
Voltage - supply span30 V
Current - supply500µA (x2 Channels)
Current - input bias20 nA
Current - output (Channel)30 mA
Operating temperature0°C~70°C(TA)
Gain bandwidth product700 kHz
PackageBulk
Slew rate0.3V/µs
Case8-SOIC (0.154\", 3.90mm Width)
Number of circuits2

Product details

The LM358DR-JF is a dual general-purpose op-amp from Texas Instruments, built around the classic LM358 architecture. The 30 mA per-channel output can drive a headphone or a small relay coil, but the slew rate limits full-power bandwidth to roughly 10 kHz at 10 V swing.

Supply range and temperature — where it lives on the board

That 3 V floor means it works in 3.3 V systems, but the input common-mode range only goes to Vcc-1.5 V — at 3.3 V supply the inputs top out around 1.8 V, so watch your signal headroom. If your board sees -20°C or 85°C ambient, you need the industrial-grade LM358 variant.

8-SOIC package — rework and footprint realities

Housed in an 8-SOIC with 0.154-inch body width and 3.90 mm body height. Surface-mount only. The 1.27 mm pin pitch is rework-friendly with a standard hot-air station — no micro-BGA tricks.

Frequently asked questions

What is the slew rate of LM358DR-JF?

The slew rate is 0.3 V/µs. This limits the maximum output voltage swing without distortion — at a 10 V peak-to-peak output, the full-power bandwidth is roughly 10 kHz. For faster signals, you would need a higher-slew-rate op-amp like the LM6171.

Can LM358DR-JF be used as a comparator?

Technically yes — the open-loop gain is high enough to drive the output to the rails with a small differential input. But the LM358 is not designed for comparator duty: the output stage saturates slowly, propagation delay is long, and there is no hysteresis. For a clean comparator function, use a dedicated part like the LM393 or TLV3501.