That 2.93V trip point is a tight fit for a 3.3V nominal rail — it catches a brown-out before the logic glitches, but leaves enough margin that a lightly loaded supply doesn't nuisance-trip during normal ripple.
60ms reset timeout — sequencing window
After the monitored voltage rises back above the threshold, the reset output stays low for a minimum of 60ms. If your design needs a longer hold-off, an external RC on the MR pin (if available) can stretch it; if 60ms is too long for a fast-booting DSP, this part may not be the right fit.
Push-pull output — no pull-up needed
The reset output is push-pull, totem pole. That means the output drives high and low actively — no external pull-up resistor required. It's a direct drive to the processor reset pin. Open-drain versions of the same function would need a pull-up to the core voltage; this one doesn't.
Housed in a 14-TSSOP (4.40mm width), surface-mount only. Not rated for the full automotive under-hood range, but fine for cabin or chassis-adjacent electronics that stay below 85°C.