Texas Instruments TPS2550DBVRG4, high-side power switch, single output, 85 mOhm typical on-resistance, 1.1 A max output, SOT-23-6 package, -40°C to 150°C junction temperature.
| Parameter | Value |
|---|---|
| Input type | Non-Inverting |
| Output type | N-Channel |
| Type | General Purpose |
| Mounting | Surface Mount |
| Voltage - load | 2.5V ~ 6.5V |
| Voltage - supply (Vcc (Vdd)) | Not Required |
| Output current | 1.1A |
| I/O channels | 1 |
| Interface | On/Off |
| Operating temperature | -40°C~150°C(TJ) |
| Package | Tape & Reel (TR) |
| Features | Slew Rate Controlled |
| Rds on | 85mOhm |
| Case | SOT-23-6 |
| Fault protection | Current Limiting (Adjustable), Over Temperature, UVLO |
| Output configuration | High Side |
| Ratio - Input:Output | 1:1 |
Built-in fault protection includes adjustable current limiting, over-temperature shutdown, and undervoltage lockout (UVLO). The current limit is set with an external resistor, letting you tailor the trip point below the 1.1 A max.
The switch features slew-rate controlled turn-on to limit inrush current into capacitive loads. The On/Off interface is non-inverting — a logic high on the enable pin turns the output on.
It protects against adjustable current limiting, over-temperature, and undervoltage lockout (UVLO).
Typical on-resistance is 85 mOhm.
Yes. The 1.1 A max output, adjustable current limit, and slew-rate control make it suitable for USB port power switching on 5 V rails, where inrush limiting and overcurrent protection are needed.