100 MHz fixed-point DSP with AEC-Q100 qualification
It carries AEC-Q100 qualification, so it is rated for under-hood and chassis-domain deployments where temperature swings and vibration are the norm. The 128 KB of on-chip Flash and 18K x 16 RAM give enough headroom for moderate motor-control or power-conversion firmware without external memory.
Combined with the AEC-Q100 stamp, this part qualifies directly into production BOMs without a separate qualification run — a sourcing advantage over commercial-temperature parts that need up-screening.
On-chip peripherals include a 16-channel 12-bit ADC, PWM with dead-band generation, watchdog timer, and a POR circuit. Connectivity covers CANbus, I²C, SCI (UART), and SPI — enough for a typical motor-drive or inverter control node talking to a host controller and sensors. The 35 general-purpose I/O pins handle local feedback and relay drives.
100-LQFP package — footprint and assembly
Supply rail and power-up
The POR block on chip means the reset pin can be tied high through a pull-up; no external supervisor is strictly required, but a voltage monitor on the 1.8 V rail is cheap insurance against brownout.