What the key ratings mean for a sensor front-end
The TLC2262AID: This is a dual CMOS op-amp from the LinCMOS series, with rail-to-rail output swing — the output can drive within millivolts of both supply rails, which matters when the ADC reference is the same supply. The 730 kHz gain-bandwidth product and 0.55 V/µs slew rate set the small-signal bandwidth ceiling: for a gain of 10, the closed-loop bandwidth is about 73 kHz, enough for most industrial sensor conditioning like thermocouple or strain-gauge amplifiers. Input bias current is 1 pA typical, and input offset voltage is 300 µV maximum — these numbers mean the part can interface directly with high-impedance sources like pH probes or piezoelectric sensors without an external buffer or trim pot. The 425 µA supply current per channel (850 µA total for both) keeps the self-heating negligible in a multi-channel board. Supply span runs from 4.4 V to 16 V, so it runs on a single 5 V rail or dual ±5 V supplies. The 50 mA output current per channel can drive a modest load or a reference input without a separate buffer.
Package and temperature grade — field-swappable in an 8-SOIC footprint
Housed in an 8-SOIC package (0.154-inch body width, 3.90 mm), the TLC2262AID fits the standard SOIC-8 land pattern. The operating temperature range is -40°C to 125°C — industrial grade that covers outdoor enclosures, engine bays, and factory-floor cabinets without derating. Surface-mount only — no through-hole variant in this series. The tube packaging means it ships in anti-static tubes of 50 or 100, not tape-and-reel, so plan for manual placement or tube-fed pick-and-place.
Compliance and sourcing posture
ROHS3 compliant per Texas Instruments.