Skip to main content
Log in
Infineon Technologies S29AL016J70FFI010 — Memory (DRAM / SRAM / Flash / EEPROM)

S29AL016J70FFI010 16 Mbit Parallel NOR Flash, 70 ns, 64-FBGA

MPNS29AL016J70FFI010
Active

Infineon AL-J series S29AL016J70FFI010, 16 Mbit parallel NOR flash, 70 ns access time, 2.7 V supply, 2M x 8 / 1M x 16 organization, -40°C to 85°C, 64-FBGA tray.

$1.66Ref. price · indicative, final on quote
Infineon Technologies S29AL016J70FFI010 datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

S29AL016J70FFI010 specifications
ParameterValue
SeriesAL-J
InterfaceParallel
MountingSurface Mount
Operating temperature high-40°C to 85°C (TA)
Frame_size16Mbit
Access time70 ns
Memory typeNon-Volatile
Package_typeTray
Memory formatFLASH
StatusActive
Supply voltage2.7
Memory organization2M x 8, 1M x 16
Write cycle time - word, page70ns

Product details

The Infineon (Cypress) S29AL016J70FFI010 is a 16 Mbit parallel NOR flash from the AL-J family. Its 70 ns access time sets the read-cycle window for the host controller.

Supply and temperature — where it runs

The 2.7 V minimum means a 3.3 V rail needs a small LDO to drop down — the part is not 3.3 V tolerant on VCC, though the I/O levels follow the supply.

Package reality — 64-ball FBGA

The 64-ball Fine-Pitch BGA (FBGA) package is the only form factor listed. This is a dense, low-profile footprint that saves board area but demands solder-paste stencil design and X-ray inspection for rework. Not a hand-solderable part — factor in assembly capability before committing the BOM.

Lifecycle — still an active line

Official product status is Active. The AL-J series has been a long-running parallel NOR flash family; the active status suggests Infineon intends to support it for the foreseeable future.

Frequently asked questions

Is the S29AL016J70FFI010 compatible with 3.3 V logic?

The I/O levels follow the VCC supply (2.7 V). A 3.3 V host controller can interface if its input thresholds accept 2.7 V CMOS levels — check the controller's VIH/VIL specs. The VCC rail itself must be 2.7 V, not 3.3 V.