600 kHz GBW and 0.3 V/µs slew rate — the bandwidth ceiling
The OP07DCSA+ is a single-channel general-purpose operational amplifier from Analog Devices, offering a gain-bandwidth product of 600 kHz and a slew rate of 0.3 V/µs. These two numbers set the practical signal ceiling: at unity gain the small-signal bandwidth extends to 600 kHz, but a full 10 V output swing slews in about 33 µs, so large-amplitude signals above roughly 5 kHz will hit the slew-rate limit before the gain-bandwidth corner.
60 µV offset and 2 nA bias — precision for a general-purpose part
Input offset voltage is trimmed to 60 µV typical, and input bias current is 2 nA. For a 10 kΩ source impedance the offset error from bias current is 20 µV — comparable to the offset itself. That makes this op-amp usable in low-speed sensor conditioning and bridge amplifiers where a few hundred microvolts of total error is acceptable, without needing a chopper-stabilized part. The supply span is 44 V maximum, with a single or split supply — ±22 V rails — covering most industrial signal-chain voltages. Operating temperature is 0 °C to 70 °C, commercial grade, so the part is specified for benchtop, lab, and indoor equipment rather than automotive or outdoor enclosures.
8-SOIC footprint, active lifecycle
Packaged in an 8-SOIC (0.154-inch width, 3.90 mm body) with the supplier device package designation 8-SOIC. The mounting type is surface mount, and the part ships in bulk. ROHS3 compliant per the manufacturer's lifecycle record, with a product status of Active — no end-of-life notice or last-time-buy date on file.