Skip to main content
Log in
Texas Instruments TUSB1210BRHBT — Sensors & Transducers

TUSB1210BRHBT USB 2.0 Transceiver – Active, Industrial Temp

MPNTUSB1210BRHBT
End of Life

Texas Instruments TUSB1210BRHBT, USB 2.0 half-duplex transceiver, 8/8 drivers/receivers, 480 Mbps data rate, 2.7V–4.8V supply, -40°C to 85°C, 32-VFQFN Exposed Pad (5x5 mm).

$2.97Ref. price · indicative, final on quote
Texas Instruments TUSB1210BRHBT datasheet (PDF)
Packaging32-VFQFN Exposed Pad
RoHSROHS3 Compliant
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

TUSB1210BRHBT specifications
ParameterValue
TypeTransceiver
MountingSurface Mount
Supply voltage2.7V ~ 4.8V
ProtocolUSB 2.0
Operating temperature-40°C ~ 85°C
DuplexHalf
PackageTape & Reel (TR); Cut Tape (CT)
Data rate480Mbps
Case32-VFQFN Exposed Pad
Receiver hysteresis50 mV
Number of drivers (Receivers)8/8

Product details

USB 2.0 half-duplex transceiver – what this part does

The TUSB1210BRHBT is a USB 2.0 transceiver operating in half-duplex mode, supporting the full 480 Mbps High-Speed data rate. It integrates 8 drivers and 8 receivers on a single die, making it suitable for multiplexed USB bus architectures where multiple channels share a common physical layer. The supply voltage range of 2.7V to 4.8V allows direct connection to 3.3V or 5V USB VBUS rails without an intermediate regulator, simplifying the power tree on the board.

Active production – sourcing posture

Production is ongoing, and the part is available through authorized distribution channels. The CT variant is convenient for prototype builds and small-run assembly without committing to full reel quantities.

Frequently asked questions

Is the TUSB1210BRHBT compatible with USB 2.0 OTG applications?

The TUSB1210BRHBT is a half-duplex transceiver that supports USB 2.0 High-Speed signaling. For OTG (On-The-Go) operation, the host/device role negotiation is typically handled by the USB controller or PHY; this transceiver provides the physical-layer interface. Confirm that your system's USB controller supports OTG session-request protocol (SRP) and host-negotiation protocol (HNP) when using this part.