Skip to main content
Log in
TLV2462AQDRG4

TLV2462AQDRG4 Dual Rail-to-Rail Op-Amp, AEC-Q100, 6.4 MHz

MPNTLV2462AQDRG4
End of Life

Texas Instruments TLV2462AQDRG4, Automotive AEC-Q100 dual general-purpose op-amp, 6.4 MHz GBW, 1.6 V/µs slew rate, rail-to-rail output, 2.7 V to 6 V supply, 550 µA per channel, -40°C to 125°C, 8-SOIC.

Texas Instruments TLV2462AQDRG4 datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Jul 2026

Specifications

TLV2462AQDRG4 specifications
ParameterValue
SeriesAutomotive, AEC-Q100
Output typeRail-to-Rail
MountingSurface Mount
Amplifier typeGeneral Purpose
Voltage - input offset500 µV
Voltage - supply span2.7 V
Current - supply550µA (x2 Channels)
Current - input bias1.3 nA
Current - output (Channel)80 mA
Operating temperature-40°C~125°C(TA)
Gain bandwidth product6.4 MHz
PackageTape & Reel (TR)
Slew rate1.6V/µs
Case8-SOIC (0.154\", 3.90mm Width)
Number of circuits2

Product details

Automotive-grade dual op-amp for sensor and actuator interfaces

It delivers a 6.4 MHz gain-bandwidth product and a 1.6 V/µs slew rate, enough bandwidth for conditioning signals from temperature, pressure, and position sensors in engine management or body-control systems. The rail-to-rail output stage lets it swing to the supply rails, useful when driving the input of an ADC or a low-side actuator without an extra rail splitter.

Supply budget and output muscle

Each amplifier draws 550 µA supply current, so the dual channel consumes 1.1 mA total — low enough for always-powered modules in a vehicle that cannot tolerate a large quiescent load.

The base product number is TLV2462, and the 'AQDRG4' suffix identifies the automotive-grade variant in the 8-SOIC package.

Frequently asked questions

Is TLV2462AQDRG4 AEC-Q100 qualified?

Yes, the TLV2462AQDRG4 is listed under the Automotive, AEC-Q100 series.

Can TLV2462AQDRG4 replace TLV2462IDR?

The TLV2462AQDRG4 is the automotive-qualified version of the commercial-grade TLV2462IDR. Both share the same dual op-amp core with 6.4 MHz GBW, rail-to-rail output, and 8-SOIC package. The AEC-Q100 qualification is the difference — the Q-grade variant is tested to automotive reliability standards, while the IDR variant is not. If your BOM requires AEC-Q100 compliance, the AQDRG4 is the correct drop-in replacement.

What is the difference between TLV2462AQDRG4 and TLV2462AIDR?

Both are automotive-grade dual op-amps with the same 6.4 MHz GBW, 1.6 V/µs slew rate, and 8-SOIC package. The difference is in the supply current and output drive: the AQDRG4 draws 550 µA per channel and delivers 80 mA output, while the AIDR variant draws 600 µA per channel with 80 mA output. The AQDRG4 is the lower-power option of the two automotive-grade siblings.