Texas Instruments LinCMOS™ TLV2432IDR, dual CMOS op-amp, 550 kHz gain bandwidth, 0.25 V/µs slew rate, rail-to-rail output, 2.7 V to 10 V supply, 100 µA per channel, 8-SOIC package, -40°C to 85°C.
| Parameter | Value |
|---|---|
| Series | LinCMOS™ |
| Output type | Rail-to-Rail |
| Mounting type | Surface Mount |
| Amplifier type | CMOS |
| Voltage - input offset | 300 µV |
| Voltage - supply span | 2.7 V |
| Current - supply | 100µA (x2 Channels) |
| Current - input bias | 1 pA |
| Current - output (Channel) | 50 mA |
| Operating temperature | -40°C ~ 85°C (TA) |
| Gain bandwidth product | 550 kHz |
| Package | Tape & Reel (TR); Cut Tape (CT) |
| Slew rate | 0.25V/µs |
| Case | 8-SOIC (0.154\", 3.90mm Width) |
| Number of circuits | 2 |
Because the input common-mode range includes ground and the output is rail-to-rail, you can run it from a single battery cell or a regulated 3.3 V bus without needing a split supply.
The part is surface-mount only, so plan for a stencil and reflow or a careful hand-solder job.
It is ROHS3 compliant, which means no exemptions for lead in solder — fine for RoHS-sensitive builds.
Yes. The supply span is 2.7 V to 10 V, so 3.3 V is well within range. The rail-to-rail output lets you swing close to the rails, and the input common-mode includes ground, making it a good fit for single-supply sensor circuits.
A faster sibling is the TLV9362IDDFR, which offers 10.6 MHz gain bandwidth and 25 V/µs slew rate in a similar dual-channel rail-to-rail CMOS topology, but at a higher supply current (2.6 mA per channel versus 100 µA). For low-power designs the TLV2432IDR remains the better fit; for higher-speed loops the TLV9362IDDFR is an option.