Texas Instruments microPOWER™ TLV2382IDR dual general-purpose op-amp, 160 kHz gain bandwidth, 0.06 V/µs slew rate, rail-to-rail output, 2.7 V to 16 V supply, 7 µA per channel, -40°C to 125°C, 8-SOIC package.
| Parameter | Value |
|---|---|
| Series | microPOWER™ |
| Output type | Rail-to-Rail |
| Mounting | Surface Mount |
| Amplifier type | General Purpose |
| Voltage - input offset | 500 µV |
| Voltage - supply span | 2.7 V |
| Current - supply | 7µA (x2 Channels) |
| Current - input bias | 1 pA |
| Current - output (Channel) | 400 µA |
| Operating temperature | -40°C ~ 125°C |
| Gain bandwidth product | 160 kHz |
| Package | Tape & Reel (TR); Cut Tape (CT) |
| Slew rate | 0.06V/µs |
| Case | 8-SOIC (0.154\", 3.90mm Width) |
| Number of circuits | 2 |
That is the trade-off for the 7 µA supply current: you get clean amplification for DC and low-frequency signals — think thermocouple conditioning, strain-gauge bridges, photodiode amplifiers with modest bandwidth, or battery-voltage monitoring. It will not track a 10 kHz square wave cleanly; for that you step up to the TLV9362 family with its 10.6 MHz GBW and 25 V/µs slew rate, but you pay for it in supply current.
The 16 V maximum covers 12 V industrial buses and multi-cell battery stacks.
Yes, the output stage is rail-to-rail, which maximizes the output voltage swing when running from low supply voltages. The input common-mode range is not rail-to-rail; the datasheet should be consulted for the exact input voltage range relative to the supply rails.
Each of the two amplifiers draws 7 µA of supply current, for a total of 14 µA for the dual device. This ultra-low quiescent current is the defining characteristic of the microPOWER™ series.
The TLV9362IDDFR is a higher-speed sibling (10.6 MHz GBW, 25 V/µs slew rate) but draws significantly more supply current. For a direct low-power replacement, stay within the microPOWER™ family; the TLV2382IDR itself is the active, current-production part. No pin-compatible second-source is listed in the official cross-reference.