Dual CMOS op-amp, 5.5 MHz, 2 V/µs — signal-chain fit
The TLV2376IDR is a dual CMOS operational amplifier from Texas Instruments, offering a 5.5 MHz gain-bandwidth product and a 2 V/µs slew rate — a pairing that suits general-purpose signal conditioning, active filtering, and sensor front-ends where moderate speed and low power are the priorities. Each of the two channels draws 815 µA supply current, keeping the total quiescent draw under 1.7 mA for the pair — a reasonable budget for battery-powered or multi-channel data-acquisition boards. Input offset voltage is trimmed to 40 µV typical, and input bias current is just 0.3 pA, so the part handles high-impedance sources like photodiodes or pH probes without adding significant DC error.
Rail-to-rail output, 2.2 V to 5.5 V supply span
The rail-to-rail output stage swings within millivolts of both supply rails, maximising dynamic range in low-voltage single-supply designs — useful when the ADC reference is the same 3.3 V or 5 V rail. Supply range spans 2.2 V to 5.5 V, so the same BOM position works across 3.3 V and 5 V systems without a regulator change. Each output can source or sink 30 mA, enough to drive a reference input, a small relay coil through a transistor, or a 50-ohm back-terminated line in short runs.
8-SOIC package, -40°C to 125°C temperature range
Housed in an 8-SOIC package (3.90 mm body width), the TLV2376IDR fits the standard SOIC-8 footprint — no layout surprises when swapping in from a similar dual op-amp. Rated for -40°C to 125°C operation, it covers industrial and automotive under-hood environments without a temperature grade downgrade. Available in Tape & Reel or Cut Tape — the reel format suits automated pick-and-place for production volumes; Cut Tape works for prototype or small-batch builds.
Active production, ROHS3 compliant
ROHS3 compliant, with no exemptions that would restrict use in EU-market equipment or RoHS-regulated supply chains.