It delivers a 2.2 MHz gain-bandwidth product and a 5.3 V/µs slew rate, with a picoamp-level input bias current of 0.7 pA. Housed in an 8-pin DIP (0.300" width, 7.62 mm pitch) for through-hole mounting, it operates from a 3 V to 16 V supply span over the 0°C to 70°C commercial temperature range. Typical applications include sensor signal conditioning, audio pre-amplification, active filters, and general-purpose analog processing in benchtop instruments, industrial controls, and consumer electronics where low input current and moderate speed are required.
The 2.2 MHz gain-bandwidth product sets the usable closed-loop bandwidth. The 5.3 V/µs slew rate supports output swings without significant distortion at these frequencies.
Package and mounting — through-hole matters
The TLC271CP comes in an 8-DIP (0.300", 7.62 mm) through-hole package. This is a breadboard-friendly, hand-solderable form factor still widely used in prototyping, education, and legacy-equipment repair. The 8-PDIP supplier package designation confirms the same footprint. If your BOM calls for surface-mount, note this part is through-hole only — check the TLV9351IDCKR or TLV9362IDDFR for an SMT alternative, but verify pinout and supply range compatibility.
No end-of-life notification or last-time-buy window is indicated.