13V/µs slew rate — what it buys the signal path
Its 13V/µs slew rate supports clean large-signal response up to several hundred kilohertz, making it a fit for audio preamplifiers, active filters, and fast-settling analog stages where a general-purpose 741-type op-amp would round the edges.
3 MHz gain bandwidth — usable frequency range
With a 3 MHz gain-bandwidth product, this part delivers a closed-loop bandwidth of 300 kHz at a gain of 10, or 30 kHz at a gain of 100. That is sufficient for audio-band processing and moderate-speed instrumentation; for video or RF paths you would step up to a wider-bandwidth amplifier.
Supply current and voltage range
Each of the two amplifiers draws 1.4 mA supply current, for a total of 2.8 mA for the dual package. The supply span is rated from 10 V to 30 V, accommodating single-supply rails from 10 V to 30 V or split supplies like ±5 V to ±15 V without a separate regulator.
JFET input characteristics
The JFET input stage gives a typical input bias current of 65 pA and an input offset voltage of 3 mV. These numbers mean the TL072CPWRE4 is well suited for high-impedance sensor interfaces and precision integrators where bipolar-input op-amps would load the source.
Housed in an 8-TSSOP package (4.40 mm width, 0.173" body), this is a surface-mount part intended for automated assembly.