Dual JFET op-amp in a through-hole DIP — what you're getting
The Texas Instruments TL072CP is a dual JFET-input operational amplifier in an 8-pin DIP package (8-DIP, 0.300" body width). Input bias current is 65 pA typical, which matters when you're buffering a high-impedance source like a piezo sensor or a photodiode without loading it down. Each of the two amplifiers draws 1.4 mA supply current, so the whole package runs under 3 mA quiescent. Supply span runs from 10 V to 30 V — single or split rails. The 3 mV input offset voltage (typical) is adequate for audio line-level work and general-purpose filtering, though you'd reach for a precision part if you're amplifying microvolt-level signals.
That means this part belongs in indoor, temperature-controlled equipment: audio mixers, bench instruments, consumer electronics, office gear. It is not rated for the engine bay, an outdoor telecom cabinet, or a factory floor that sees freezing starts. If your BOM calls for -40°C operation, you need an industrial-grade JFET op-amp like the TLV9362 or a similar extended-temp part.
Lifecycle reality — obsolete, sourced through independent channels
The TL072CP is marked obsolete by Texas Instruments. That means TI no longer manufactures or accepts orders for this specific through-hole variant. There is no official TI successor order code for the TL072CP listed in the lifecycle record — the broader TL072 family continues in surface-mount packages (SOIC-8, TSSOP-8), but the DIP-8 version is end-of-life. Sourcing now runs through independent distribution and the surplus market.
Package and assembly fit
Through-hole 8-DIP (0.300" row spacing, 7.62 mm body width). No MSL rating to worry about — DIP packages are moisture-insensitive and survive reflow or hand-solder without a bake step. The tube shipping medium is standard for DIP parts; pick-and-place requires a tube feeder or manual insertion. If your production line is all surface-mount, the TL072CD (SOIC-8) or TL072ID (SOIC-8) are the same die in a reflow-friendly package.