STMicroelectronics TL061CP, JFET-input operational amplifier, 1 circuit, 8-DIP through-hole, 1 MHz gain-bandwidth, 3.5 V/µs slew rate, 200 µA supply, 0°C to 70°C.
| Parameter | Value |
|---|---|
| Mounting | Through Hole |
| Amplifier type | J-FET |
| Voltage - input offset | 3 mV |
| Voltage - supply span | 36 V |
| Current - supply | 200µA |
| Current - input bias | 30 pA |
| Operating temperature | 0°C ~ 70°C |
| Gain bandwidth product | 1 MHz |
| Package | Tube |
| Slew rate | 3.5V/µs |
| Case | 8-DIP (0.300\", 7.62mm) |
| Number of circuits | 1 |
Runs from a 7 V to 36 V single or dual supply.
Supplied in Tube, 8-DIP (0.300", 7.62 mm) body, through-hole mount. The 8-PDIP footprint is socket-compatible and protoboard-friendly — useful for repair swaps, breadboard prototypes, or low-volume builds where SMT reflow isn't available.
There is no official replacement because the TL061CP is still active. If you need a pin-compatible JFET op-amp with higher bandwidth, the TL071 series (same DIP-8 footprint) offers 3 MHz GBW and 13 V/µs slew rate but draws roughly 1.4 mA supply current — a trade-off between speed and power.
Yes — the TL061CP operates from a single supply between 7 V and 36 V. The input common-mode range does not include the negative rail, so for true zero-input operation you need to bias the inputs above ground.
Standard JFET op-amp pinout for an 8-DIP package: pin 2 (inverting input), pin 3 (non-inverting input), pin 6 (output), pin 4 (V-), pin 7 (V+). Pins 1 and 5 are offset null; pin 8 is NC.
Both are single JFET op-amps in DIP-8. The TL061CP runs at 1 MHz GBW and 3.5 V/µs slew rate while drawing 200 µA supply current. The TL071 offers 3 MHz GBW and 13 V/µs but draws about 1.4 mA — the TL061CP is the low-power choice for battery or multi-channel designs where speed headroom is not critical.