240 V/µs Slew Rate — Dual Voltage-Feedback Op-Amp in 8-HVSSOP
Each channel can source or sink 100 mA while drawing 8.5 mA supply current per amplifier. The input offset voltage is 2.5 mV with 2.5 µA input bias current. Supply span runs from 9 V to 32 V, suiting it for single- or split-supply rails in industrial signal conditioning, video distribution, and high-speed data acquisition front ends.
Package and Thermal — Exposed Pad Needs Via Stitching
Without adequate via stitching, the junction temperature rises quickly under continuous 100 mA output per channel. The 3.00 mm body width fits standard MSOP-8 footprints with the pad extension; verify the land pattern against the datasheet recommended layout before tape-out.
Slew Rate and Bandwidth — What They Mean for Signal Fidelity
The 240 V/µs slew rate means this op-amp can reproduce a 10 V peak-to-peak sine wave up to roughly 3.8 MHz without slew-rate-induced distortion — useful for driving video lines or fast pulse amplifiers. The 70 MHz -3 dB bandwidth supports closed-loop gains up to 10× while maintaining a gain-bandwidth product around 700 MHz. In practice, the large-signal response is slew-limited before the small-signal bandwidth rolls off, so the 240 V/µs figure is the one to check when the output swing exceeds a few volts.