CAN physical-layer transceiver for 5V industrial buses
The part integrates one driver and one receiver, with 200 mV of receiver hysteresis to reject bus noise and ensure clean signal recovery on long or noisy cable runs.
5 V supply — 3.3 V logic interface note
The logic input pins (TXD) and output (RXD) swing with the VCC rail, so direct connection to a 3.3 V controller's UART pins exceeds the logic-low threshold but leaves the logic-high margin thin. A level shifter or a resistor divider on TXD and a clamp on RXD is recommended when pairing with a 3.3 V MCU.