Texas Instruments SN65HVD231D CANbus transceiver, half-duplex, 1 Mbps data rate, 3 V to 3.6 V supply, 8-SOIC (3.90 mm width), -40°C to 85°C operating temperature, 100 mV receiver hysteresis.
| Parameter | Value |
|---|---|
| Type | Transceiver |
| Mounting | Surface Mount |
| Supply voltage | 3V ~ 3.6V |
| Protocol | CANbus |
| Operating temperature | -40°C~85°C |
| Duplex | Half |
| Package | Tube |
| Data rate | 1Mbps |
| Case | 8-SOIC (0.154\", 3.90mm Width) |
| Receiver hysteresis | 100 mV |
| Number of drivers (Receivers) | 1/1 |
It handles the standard CAN data rate of 1 Mbps and comes in an 8-SOIC surface-mount package. The 100 mV receiver hysteresis gives it decent noise rejection on the differential bus lines — useful in factory-floor or motor-drive environments where electrical noise couples into the twisted pair.
ESD sensitivity is typical for CMOS transceivers; a grounded iron and a wrist strap are enough for field replacement.
No, they are not equivalent. The SN65HVD230D runs on a 5 V supply, while the SN65HVD231D is a 3.3 V part. The pinouts are not the same, so they cannot be swapped without board changes.
The SN65HVD231D is listed as RoHS compliant per TI's standard lead-free finish for this product family.
No, the SN65HVD231D is not 5 V tolerant.