Active quad op-amp for low-power signal chains
The OPA4342EA/250: Each of the four channels draws 150 µA supply current, and the rail-to-rail output swing allows the amplifier to operate from a 2.7 V to 5.5 V single supply — a fit for battery-powered or 3.3 V/5 V sensor interfaces where headroom is tight. The 1 MHz gain-bandwidth product and 1 V/µs slew rate cover general-purpose filtering, buffering, and low-frequency signal conditioning; the 0.2 pA input bias current suits high-impedance sources like photodiode or pH probe front-ends.
14-TSSOP footprint and industrial temperature range
Housed in a 14-TSSOP package (4.40 mm body width), the part occupies a compact surface-mount footprint — the 0.65 mm lead pitch and standard SOIC-like land pattern make it straightforward to route on a two-layer board. Rated for -40°C to 85°C ambient operation, the OPA4342EA/250 is specified across the industrial temperature band, covering outdoor telecom cabinets, factory-floor sensor modules, and automotive cabin electronics.
Sourcing and compliance
The OPA4342EA/250 carries ROHS3 compliance and is available in Tape & Reel (250-unit reel) or Cut Tape — the reel format suits automated pick-and-place; Cut Tape works for prototype or low-volume builds.