Dual op amp, 3.5 MHz GBW, rail-to-rail output
The Texas Instruments LMV772MMX/NOPB is a dual-channel general-purpose operational amplifier from the LMV® series, packaged in an 8-VSSOP (also available in 8-TSSOP, 8-MSOP) for surface-mount assembly. It delivers a 3.5 MHz gain-bandwidth product and a 1.4 V/µs slew rate, making it suitable for signal conditioning in sensor interfaces, active filters, and data acquisition front-ends.
Parametric fit: bandwidth, drive, and precision
With a 3.5 MHz gain-bandwidth product, this op amp supports signal bandwidths up to a few hundred kHz at moderate closed-loop gains — enough for audio processing, motor current sensing, or ADC driver stages in industrial control. The 1.4 V/µs slew rate ensures the output can track fast edges without significant distortion for signals below roughly 200 kHz at full output swing. Supply current is 600 µA per channel (1.2 mA total for the dual), which keeps the thermal budget low in a densely populated board. Input bias current is just 0.23 pA typical, so high-impedance sources like photodiode or pH probe front-ends see negligible loading error. Input offset voltage is 250 µV maximum, adequate for 12-bit systems with a 2.5 V reference. Each channel can source or sink 75 mA of output current — enough to drive a headphone load, a small relay coil, or the input of a successive-approximation ADC without an external buffer. The rail-to-rail output stage swings within millivolts of the supply rails, maximizing dynamic range in low-voltage single-supply designs.
Supply range, temperature grade, and package
The LMV772MMX/NOPB operates from a single supply of 2.7 V to 5.5 V, or from dual supplies of ±1.35 V to ±2.75 V. This span covers common 3.3 V and 5 V logic rails as well as battery-powered 3 V systems. The industrial temperature range of -40°C to +125°C qualifies it for under-hood automotive, factory-floor sensor modules, and outdoor telecom equipment. The 8-VSSOP package (3.00 mm width) is a compact footprint for space-constrained designs, with a 0.65 mm pin pitch that routes easily on two-layer boards. The same die is also offered in 8-TSSOP and 8-MSOP variants — the LMV772MMX/NOPB suffix specifies the VSSOP package in tape-and-reel or cut-tape format.
Active production, RoHS3, and sourcing posture
Texas Instruments lists the LMV772MMX/NOPB as Active in production — no end-of-life notice or last-time-buy window is in effect. The part is ROHS3 Compliant (per), meeting the EU RoHS exemption-free requirements for lead-free soldering. It belongs to the LMV® series, a family of low-voltage, low-power op amps designed for general-purpose signal conditioning. Sourced through independent distribution channels, the part is quoted to order against your BOM quantity. Availability and current pricing are confirmed at the time of RFQ — no stock-holding claim is made here, but the supply chain is active for this order code.