17 MHz GBW, 0.1 pA input bias — signal-chain fit for precision front ends
The LMP7711MK/NOPB is a single-channel general-purpose op amp from TI's LMP® and PowerWise® series, delivering 17 MHz gain-bandwidth product and an 11.5 V/µs slew rate — enough bandwidth to handle fast sensor signals or active filters up to a few megahertz without excessive phase lag. Input bias current is 0.1 pA typical, and input offset voltage is 10 µV typical, making this part suitable for high-impedance transducer interfaces (photodiodes, pH probes, piezoelectric pickups) where bias current drift would otherwise swamp the signal. Rail-to-rail output swing lets it run on a single 1.8 V to 5.5 V supply and still use the full ADC input range — no negative rail needed for ground-referenced signals.
Active lifecycle, RoHS3, industrial temperature range
RoHS3 compliant and rated for -40°C to 125°C operation, covering automotive under-hood and industrial enclosure environments without a temperature grade downgrade.
Package and supply — SOT-23-THIN, 1.8 V to 5.5 V
Housed in a 6-pin SOT-23-THIN (TSOT-23-6) package — same footprint as the standard SOT-23-6 but thinner, saving board height in compact or multi-layer stacks. Supply current is 1.15 mA typical, keeping the power budget lean for battery-powered or low-dropout regulator rails. Output can source or sink 66 mA per channel — enough to drive a moderate load or a reference input without an external buffer.
Cross-reference check: TLV9351IDCKR
The TLV9351IDCKR is a close parametric peer — same package (SOT-23-THIN), same rail-to-rail output, same single-supply range, and a comparable 10 MHz GBW with 20 V/µs slew rate. The LMP7711MK/NOPB offers a lower 0.1 pA input bias versus 10 pA, and a tighter 10 µV offset versus 350 µV, so it pulls ahead in precision dc or high-impedance applications. The TLV9351IDCKR draws roughly half the supply current (0.6 mA vs 1.15 mA), making it the better fit for a strict power budget where dc accuracy can relax.