Dual op-amp with 18 MHz GBW and rail-to-rail output
It delivers an 18 MHz gain-bandwidth product and a 25 V/µs slew rate, with rail-to-rail output swing. Supply range spans 1.8 V to 24 V, suiting it for single-supply designs from battery-powered instruments to industrial control loops. Each channel draws 750 µA quiescent current, keeping the power budget manageable in multi-stage signal chains.
18 MHz gain-bandwidth — what it means for signal conditioning
At 18 MHz GBW, this amplifier supports closed-loop gains up to 10× while maintaining a 1.8 MHz small-signal bandwidth — enough for audio-frequency filtering, sensor amplification, and ADC driver stages. The 25 V/µs slew rate ensures the output can swing several volts in under a microsecond, preserving pulse integrity in multiplexed data-acquisition front ends.
Rated from 1.8 V to 24 V, the LM6142BIMX-TI can run off a single lithium cell or a standard 24 V industrial rail. Rail-to-rail output lets it swing close to the supply rails, maximizing dynamic range in low-voltage designs. Each channel can source or sink 22 mA, enough to drive a 2 kΩ load to within 100 mV of the rails.
Input offset voltage is 1.3 mV typical, and input bias current is 174 nA — adequate for general-purpose signal conditioning where precision below 100 µV is not required.
Package and footprint
The supplier device package is 8-SOIC. Standard SOIC-8 footprint, no exposed pad — layout is straightforward with 0.1 µF decoupling close to each supply pin.
Lifecycle and compliance
RoHS non-compliant per the listing; verify local exemption requirements if your BOM mandates RoHS.