Skip to main content
Log in
Texas Instruments LM358PWRG4 — Analog & Data Acquisition

LM358PWRG4 Texas Instruments Dual Op-Amp, 700 kHz GBW

MPNLM358PWRG4
End of Life

Texas Instruments LM358PWRG4, dual general-purpose op-amp, 700 kHz gain bandwidth, 0.3 V/µs slew rate, 3 V to 30 V supply, 500 µA per channel supply current, 8-TSSOP surface-mount package, 0°C to 70°C operating temperature.

$0.3700Ref. price · indicative, final on quote
Texas Instruments LM358PWRG4 datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Jul 2026

Specifications

LM358PWRG4 specifications
ParameterValue
MountingSurface Mount
Amplifier typeGeneral Purpose
Voltage - input offset3 mV
Voltage - supply span30 V
Current - supply500µA (x2 Channels)
Current - input bias20 nA
Current - output (Channel)40 mA
Operating temperature0°C~70°C(TA)
Gain bandwidth product700 kHz
PackageTape & Reel (TR); Cut Tape (CT)
Slew rate0.3V/µs
Case8-TSSOP (0.173\", 4.40mm Width)
Number of circuits2

Product details

Dual op-amp in a narrow 8-TSSOP — the BOM-fit tier

It runs from a single or split supply spanning 3 V to 30 V, drawing 500 µA per channel — under 1 mA total quiescent for the two amplifiers. Gain-bandwidth product is 700 kHz with a 0.3 V/µs slew rate. This is the classic LM358 core in a smaller surface-mount footprint, suited for signal conditioning loops where the closed-loop bandwidth stays under a few tens of kilohertz.

700 kHz GBW and 0.3 V/µs slew — what they set

At a closed-loop gain of 10, the usable bandwidth is about 70 kHz. The 0.3 V/µs slew rate means a 1 V output step slews in roughly 3.3 µs — fine for DC-level shifting, sensor buffering, and audio line-level paths, but not for fast pulse or video stages.

For a production BOM that already qualifies the 8-TSSOP footprint, this part is a low-risk dual-sourcing candidate alongside other LM358-family surface-mount variants.

Frequently asked questions

What is the difference between LM358P and LM358PWRG4?

The LM358P is the through-hole DIP-8 version; the LM358PWRG4 is the surface-mount 8-TSSOP variant. Both share the same LM358 core — same 700 kHz GBW, 0.3 V/µs slew rate, and 3 V to 30 V supply range. The difference is the package and the reel format (Tape & Reel for the PWRG4).

Can I use LM358PWRG4 as a replacement for LM358P?

Electrically yes — the LM358PWRG4 is the same amplifier in a surface-mount TSSOP-8 package. The through-hole LM358P footprint will not accept the TSSOP body. For a new board layout or a redesign migrating to SMT, the LM358PWRG4 is a direct functional substitute.