Skip to main content
Log in
Texas Instruments LM2904VQPWRCT — Analog & Data Acquisition

TI LM2904VQPWRCT Dual Op-Amp, 700 kHz, 8-TSSOP

MPNLM2904VQPWRCT
Active

Texas Instruments LM2904VQPWRCT, dual general-purpose operational amplifier, 700 kHz gain bandwidth, 0.3 V/µs slew rate, 3 V to 30 V supply, push-pull output, -40°C to 125°C, 8-TSSOP package, Bulk.

Texas Instruments LM2904VQPWRCT datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Jul 2026

Specifications

LM2904VQPWRCT specifications
ParameterValue
Output typePush-Pull
MountingSurface Mount
Amplifier typeGeneral Purpose
Voltage - input offset3 mV
Voltage - supply span30 V
Current - supply500µA (x2 Channels)
Current - input bias20 nA
Current - output (Channel)40 mA
Operating temperature-40°C ~ 125°C (TA)
Gain bandwidth product700 kHz
PackageBulk
Slew rate0.3V/µs
Case8-TSSOP (0.173\", 4.40mm Width)
Number of circuits2

Product details

700 kHz GBWP — adequate for low-frequency signal chains

The 20 nA input bias current and 3 mV input offset voltage are typical for a bipolar-input general-purpose amplifier; no need for a precision op-amp in a temperature-stabilised environment. Each channel draws 500 µA quiescent supply current, keeping the total power under 1 mA per package at no load.

The Bulk shipping form means it arrives in tubes or loose pieces rather than tape-and-reel — factor that into your pick-and-place feeder setup if you automate the 8-TSSOP body.

Frequently asked questions

Can the LM2904VQPWRCT be used as a comparator?

The LM2904 is an op-amp, not a comparator. It lacks the open-collector output stage and internal hysteresis of a dedicated comparator. Running it open-loop as a comparator can cause saturation recovery delays and increased supply current — use a part like the TLV3701 if comparator function is needed.

Is the LM2904VQPWRCT RoHS compliant?

TI's standard 8-TSSOP packages for the LM2904 family are typically RoHS-compliant and lead-free, but verify the date-code-specific compliance statement on the manufacturer's packaging label before accepting into a RoHS-required line.