Through-hole 20-DIP footprint for legacy and breadboard builds
The CD74HC374E comes in a 20-pin DIP (0.300-inch, 7.62 mm pitch) through-hole package, making it a drop-in fit for breadboard prototyping, legacy through-hole PCBs, and designs where socketed replacement is preferred over reflow. With a 60 MHz maximum clock frequency and 28 ns propagation delay at 6 V, 50 pF load, this 8-bit register handles moderate-speed data latching in control and interface applications.
Wide supply and temperature range for industrial environments
Operates from 2 V to 6 V, covering both 3.3 V and 5 V logic rails without a separate level translator. The -55°C to 125°C operating temperature range suits industrial, automotive, and outdoor equipment where ambient extremes are expected. Quiescent current is just 8 µA, keeping the power budget low in battery-backed or always-on sections. Outputs source or sink 7.8 mA each, enough to drive standard CMOS inputs and low-power LEDs directly.
Tri-state outputs and positive-edge clocking simplify bus arbitration
Tri-state, non-inverted outputs let multiple flip-flops share a common data bus — the outputs go high-impedance when the output-enable pin is inactive, preventing contention on a shared bus. Positive-edge triggered clocking means data is captured on the rising edge of the clock signal, aligning with standard synchronous design practices. Input capacitance is 10 pF, a light load on the driving clock source.
Active production with full RoHS3 compliance
Sourced through independent distribution channels.