Skip to main content
Log in
Texas Instruments AM26LV32EMDREP — Interface & Transceivers

TI AM26LV32EMDREP RS422/RS485 Receiver, -55°C to 125°C

MPNAM26LV32EMDREP
Active

Texas Instruments AM26LV32EMDREP, RS422/RS485 Receiver, 0/4 Drivers/Receivers, 3V to 3.6V Supply, 35 mV Hysteresis, -55°C to 125°C, 16-SOIC (0.154", 3.90mm Width), Surface Mount.

$6.7200Ref. price · indicative, final on quote
Texas Instruments AM26LV32EMDREP datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

AM26LV32EMDREP specifications
ParameterValue
TypeReceiver
MountingSurface Mount
Supply voltage3V ~ 3.6V
ProtocolRS422, RS485
Operating temperature-55°C~125°C
PackageTape & Reel (TR); Cut Tape (CT)
Case16-SOIC (0.154\", 3.90mm Width)
Receiver hysteresis35 mV
Number of drivers (Receivers)0/4

Product details

Quad RS422/RS485 receiver for 3.3V differential buses

The AM26LV32EMDREP: It provides four independent receivers in a single 16-SOIC package, each with 35 mV of hysteresis for noise rejection on long cable runs.

For defense and aerospace BOMs that require a guaranteed receiver over the entire Mil-Std temperature span, this part fits without derating. The 16-SOIC package is surface-mount, so board assembly follows standard JEDEC profiles, but the die and package materials are qualified for the extended range.

Frequently asked questions

What is the difference between AM26LV32 and AM26LV32E?

The AM26LV32E variant includes enhanced ESD protection on the bus pins compared to the base AM26LV32. The 'E' suffix parts are preferred for applications where the cable interface is exposed to electrostatic discharge events. Both are quad RS422/RS485 receivers with the same pinout and supply range.

Is AM26LV32EMDREP compatible with 5V systems?

The supply voltage is 3V to 3.6V, so the VCC pin must connect to a 3.3V rail. The receiver inputs are designed for RS422/RS485 differential signals with a common-mode range that can accommodate 5V bus voltages, but the part itself is not a 5V-logic device. Level translation on the logic-side outputs may be needed if the downstream UART or controller runs at 5V.