Dual JFET op-amp with AEC-Q100 screening
It operates from a single or split supply spanning 6 V to 36 V and draws 1.4 mA per amplifier quiescent current. The JFET input stage delivers 20 pA typical input bias current and 3 mV maximum input offset voltage, making it suited for high-impedance signal conditioning, active filters, and ADC driver stages where input leakage must be minimized.
Automotive-grade screening, commercial temperature range
The AEC-Q100 stamp here reflects the screening and quality flow rather than a wide temperature rating, so it fits applications where the assembly environment is controlled (cabin electronics, infotainment, test equipment) but not under-hood or engine-bay exposure where -40°C to 125°C would be needed.
Slew rate and bandwidth: what they mean for signal fidelity
The 16 V/µs slew rate supports large-signal swings up to roughly 250 kHz at full output before slew-induced distortion sets in. For small-signal applications, the 4 MHz gain-bandwidth product defines the closed-loop bandwidth at a given gain—unity-gain bandwidth is 4 MHz, dropping to 400 kHz at a gain of 10. These numbers are typical for a general-purpose JFET op-amp and are adequate for audio processing, motor-current sensing at moderate bandwidths, and low-frequency ADC front-ends.
The supplier device package is designated 8-SO.