STMicroelectronics STM32F1 series, ARM Cortex-M3, 32-Bit Single-Core, 36MHz, 64KB (64K x 8) FLASH, 10K x 8 RAM, 100-LQFP.
| Parameter | Value |
|---|---|
| Series | STM32F1 |
| Mounting | Surface Mount |
| Oscillator type | Internal |
| Program memory type | FLASH |
| Voltage - supply (Vcc (Vdd)) | 2V ~ 3.6V |
| Operating temperature | -40°C~85°C(TA) |
| Speed | 36MHz |
| Package | Tray |
| RAM size | 10K x 8 |
| Core size | 32-Bit Single-Core |
| Peripherals | DMA, PDR, POR, PVD, PWM, Temp Sensor, WDT |
| Connectivity | I²C, IrDA, LINbus, SPI, UART/USART |
| Number of i (O) | 80 |
| Core processor | ARM® Cortex®-M3 |
| Case | 100-LQFP |
| Data converters | A/D 16x12b |
| Program memory size | 64KB (64K x 8) |
The STM32F101V8T6: 64 KB Flash and 10 KB SRAM limit firmware to a modest application. On-chip peripherals include DMA, a temperature sensor, PWM timers, and a watchdog, plus I²C, SPI, UART/USART, LIN, and IrDA. A 12-bit ADC with 16 multiplexed channels covers analog sensing.
An internal oscillator is available, so a minimal system can start up without an external crystal — useful for cost-sensitive or space-constrained boards.
The STM32F103V8T6 is pin-compatible and shares the same 100-LQFP footprint, but runs at 72 MHz and includes a second ADC and USB. The trade-off is higher core speed and peripheral count versus the STM32F101's lower power draw and cost. For a direct drop-in with the same 36 MHz ceiling, the STM32F101VBT6 doubles the Flash to 128 KB while keeping the same pinout.
Core: ARM Cortex-M3 at 36 MHz. Memory: 64 KB Flash, 10 KB SRAM. I/O: 80 lines. Package: 100-LQFP (14x14 mm). Supply: 2.0 V to 3.6 V. Temperature: -40 to 85 °C. ADC: 16-channel 12-bit. Connectivity: I²C, SPI, UART/USART, LIN, IrDA.
Programming is done via the Serial Wire Debug (SWD) interface using a standard ARM debug probe such as ST-LINK or J-Link. The internal Flash is programmed through the SWD port; no external programmer is required beyond the probe. ST's STM32CubeProgrammer or any ARM-compatible IDE (Keil, IAR, STM32CubeIDE) handles the flash load.