Skip to main content
STMicroelectronics M24C32-WMN6P — Memory (DRAM / SRAM / Flash / EEPROM)

M24C32-WMN6P I²C EEPROM 32Kbit 1 MHz NRND —

MPNM24C32-WMN6P
NRND

STMicroelectronics M24C32-WMN6P, 32Kbit I²C EEPROM organized 4K × 8, 1 MHz clock, 2.5–5.5 V supply, -40°C to 85°C, 8-SOIC package

$0.2800Ref. price · indicative, final on quote
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Jul 2026

Specifications

M24C32-WMN6P specifications
ParameterValue
Memory typeNon-Volatile
MountingSurface Mount
Supply voltage2.5V ~ 5.5V
Clock frequency1 MHz
Memory interfaceI²C
Operating temperature-40°C ~ 85°C (TA)
PackageTube
TechnologyEEPROM
Access time450 ns
Memory size32Kbit
Memory formatEEPROM
Case8-SOIC (0.154\", 3.90mm Width)
Memory organization4K x 8
Write cycle time - word, page5ms

Product details

What this 32Kbit I²C EEPROM brings to the board

The M24C32-WMN6P is a 32Kbit serial EEPROM from STMicroelectronics, organized as 4K × 8 and accessed over an I²C bus running up to 1 MHz. That 1 MHz clock means a full 32Kbit page read completes in about 32 ms — fast enough for configuration storage or parameter logging in a motor drive or outdoor controller.

The M24C32-WMN6P is still orderable through distribution channels; we can quote it against your BOM quantity. For new designs, plan on the M24C32-R series or a pin-compatible 32Kbit I²C EEPROM from a second source.

Package and footprint — 8-SOIC

The 450 ns access time is the random read access — the I²C bus protocol adds addressing overhead, but the memory itself responds within that window.

Frequently asked questions

What is the replacement for M24C32-WMN6P?

STMicroelectronics has not published a direct factory replacement for the M24C32-WMN6P. For new designs, consider the M24C32-R series or a pin-compatible 32Kbit I²C EEPROM from another manufacturer. The 8-SOIC footprint is standard, so many alternatives fit the same board.

Can I use M24C32-WMN6P in new designs?

No — the NRND status means STMicroelectronics does not recommend it for new designs. Use it only for repair or production runs of existing boards.