Skip to main content
Log in
Microchip Technology DSC6001JE2B-024.0000T — Crystals & Oscillators

DSC6001JE2B-024.0000T MEMS XO – 24 MHz CMOS, AEC-Q100

MPNDSC6001JE2B-024.0000T
Active

Microchip Technology DSC6001JE2B-024.0000T, XO (Standard) 24 MHz, CMOS output, MEMS resonator, 4-VLGA package, AEC-Q100 qualified

Microchip Technology DSC6001JE2B-024.0000T datasheet (PDF)
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

DSC6001JE2B-024.0000T specifications
ParameterValue
TypeXO (Standard)
SeriesDSC60XXB
MountingSurface Mount
Supply voltage1.71V ~ 3.63V
Current - supply1.3mA (Typ)
Frequency24 MHz
Frequency stability±25ppm
Operating temperature-20°C~70°C
Size (Dimension)0.098\" L x 0.079\" W (2.50mm x 2.00mm)
Height - seated0.035\" (0.89mm)
OutputCMOS
PackageTape & Reel (TR)
RatingsAEC-Q100
FunctionEnable/Disable
Base resonatorMEMS
Case4-VLGA

Product details

The DSC6001JE2B-024.0000T is a 24 MHz MEMS-based oscillator from Microchip's DSC60XXB series, delivering a CMOS output from a 1.71V to 3.63V supply rail.

Housed in a 4-VLGA package measuring 2.50 mm x 2.00 mm with a seated height of 0.89 mm, this is a small, low-profile surface-mount part. The 4-pin VLGA has a central ground pad that needs a good solder joint for thermal and electrical contact—make sure the stencil aperture covers it. Under hot air, the part lifts cleanly if the pad is pre-tinned; the small mass means it reflows fast, so watch the profile to avoid cold joints on the enable pin.

Frequently asked questions

Is DSC6001JE2B-024.0000T AEC-Q100 qualified?

Yes, it carries AEC-Q100 rating, making it suitable for automotive applications that require the temperature and reliability stress testing defined by that standard.

What is the output type and frequency of DSC6001JE2B-024.0000T?

It outputs a CMOS signal at 24 MHz. The CMOS rail swings between the supply voltage and ground, so it interfaces directly with 1.8V, 2.5V, or 3.3V logic without level translation.

Can DSC6001JE2B-024.0000T replace a crystal oscillator?

Functionally yes—it provides a 24 MHz clock reference with ±25 ppm stability, similar to a crystal oscillator. However, the MEMS resonator inside is less sensitive to shock and vibration than a quartz crystal, and the Enable/Disable pin gives a power-saving feature that a raw crystal does not. The 4-VLGA package is a different footprint from most quartz oscillators, so the PCB layout must match the 2.50 mm x 2.00 mm land pattern.