Skip to main content
Log in
Microchip Technology DSC1101AE1-011.0000T — Crystals & Oscillators

DSC1101AE1-011.0000T MEMS XO 11 MHz CMOS Oscillator

MPNDSC1101AE1-011.0000T
Active

Microchip DSC1101AE1-011.0000T, XO (Standard) MEMS oscillator, 11 MHz, CMOS output, 2.25V–3.5V supply, Standby (Power Down) function, -20°C to 70°C, 6-SMD No Lead Exposed Pad package, Tape & Reel.

Microchip Technology DSC1101AE1-011.0000T datasheet (PDF)
Sourced new & surplus through independent channelsAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

DSC1101AE1-011.0000T specifications
ParameterValue
TypeXO (Standard)
SeriesDSC1101
MountingSurface Mount
Voltage2.25V ~ 3.5V
Current - supply35mA
Frequency11 MHz
Frequency stability±50ppm
Operating temperature-20°C~70°C
Size (Dimension)0.276\" L x 0.197\" W (7.00mm x 5.00mm)
Height - seated0.035\" (0.90mm)
OutputCMOS
PackageTape & Reel (TR)
FunctionStandby (Power Down)
Base resonatorMEMS
Case6-SMD, No Lead Exposed Pad

Product details

11 MHz MEMS XO with standby — what it replaces

The DSC1101AE1-011.0000T: This is a MEMS-based oscillator outputting 11 MHz CMOS — it directly replaces a quartz crystal + load caps + inverter buffer on the BOM, saving two passives and a layout trace.

The supply voltage spans 2.25 V to 3.5 V — one BOM line covers 2.5 V and 3.3 V rails without a second oscillator variant.

Active — no end-of-life pressure

Listed as Active — no NRND flag, no last-time-buy clock. The DSC1101 series is Microchip's current MEMS oscillator family; no successor part has been published.

Frequently asked questions

Where can I buy DSC1101AE1-011.0000T and check stock?

Submit an RFQ through this page to get a firm lead time and price for your quantity.

Is DSC1101AE1-011.0000T a direct replacement for a standard quartz crystal oscillator?

Yes — it is a drop-in XO (Standard) with CMOS output. The MEMS resonator means it starts faster and handles vibration better than quartz, but the electrical interface (power, ground, output, enable) follows the same 6-pin footprint as a standard quartz oscillator in the same package. No external load capacitors are needed.

Does DSC1101AE1-011.0000T have a standby / power-down function?

Yes — the function is Standby (Power Down). When the enable pin is pulled low, the output goes to high-impedance and the internal oscillator stops, reducing supply current well below the 35 mA active max. The exact standby current figure is not listed in the spec table; check the DSC1101 datasheet for the typical value.