No successor part is listed on the manufacturer's lifecycle record for this order code. Production has ended, and the only available units are from surplus or distributor inventory that was pulled before the last-time-buy cutoff.
110 mOhm Rds(on) and 2.3 A output — load sizing
This is a single-channel high-side switch with a typical on-resistance of 110 mOhm and a maximum continuous output current of 2.3 A. The 110 mOhm Rds(on) at 25°C sets the conduction loss floor — at 2.3 A the I²R dissipation is about 0.58 W, which the TO-220-5 package can handle with adequate heatsinking, but derating is needed as junction temperature rises toward the 150°C limit.
TO-220-5 footprint — not a standard TO-220
The package is a 5-lead TO-220 (TO-220AB with 5 leads), not the common 3-lead TO-220. The extra pins carry the input, output, and enable/logic signals. The through-hole mounting requires a 5-pin footprint — a standard 3-pin TO-220 pad layout will not work. Confirm the board has the correct 5-pin pattern before committing to a surplus lot.
Non-inverting input — logic compatibility
The input type is non-inverting, meaning the switch turns on when the logic input is high. The load supply range is 6 V to 28 V, covering nominal 12 V and 24 V industrial and automotive rails. The 150°C junction rating suits under-hood or high-ambient environments, but the obsolete status means any new design should look at current Infineon high-side switch families (e.g., PROFET) for a drop-in or near-drop-in replacement.