48 MHz Cortex-M0 with USB and CAN in a 28-pin package
It packs 16 KB of Flash and 6 KB of SRAM, along with a USB 2.0 full-speed interface and a CANbus controller, all in a compact 28-UFQFPN package measuring 4x4 mm. This combination makes it a strong fit for space-constrained industrial nodes, sensor hubs, and USB-enabled control modules where cost and board area are primary constraints.
Memory and peripheral budget for control-loop designs
With 16 KB of Flash and 6 KB of SRAM, this MCU is sized for single-loop control, simple protocol stacks (USB DFU, CANopen), and sensor fusion firmware. On-chip DMA, PWM timers, and I²S support reduce CPU load for motor drive or audio sample streaming.
Connectivity options for mixed-signal fieldbus nodes
The USB interface supports DFU for firmware updates over a standard cable, while CAN enables integration into industrial automation backbones. The 24 available I/O pins are enough for a keypad, display, or encoder interface alongside the serial buses.
ST continues to manufacture the STM32F0 series, and this part is available through authorized distribution channels.