Supply range spans 4 V to 36 V, covering single 5 V logic rails up to ±15 V industrial supplies.
Through-hole package — breadboard and repair friendly
The 8-DIP (0.300" width, 7.62 mm pitch) package is a through-hole part that fits standard breadboards, prototyping boards, and socketed production boards. Hand-soldering is straightforward — no hot-air or reflow oven needed. The supplier device package is 8-PDIP. This makes the OP113FP a practical choice for one-off builds, field repairs, and low-volume runs where surface-mount assembly isn't available.
The 3.4 MHz gain-bandwidth product sets the usable closed-loop gain bandwidth: at a gain of 10, expect a 340 kHz small-signal bandwidth. The 1.2 V/µs slew rate limits large-signal response — a 10 V peak-to-peak output step slews in about 8.3 µs. For audio or low-frequency ADC drive, that's fine; for fast pulse amplification or high-frequency filtering, a faster part would be needed. The 600 nA input bias current is moderate — acceptable for most general-purpose circuits but worth checking against source impedance in high-gain stages.
Active lifecycle — no obsolescence worry
For a BOM line, this means no imminent supply disruption and no forced redesign.