Skip to main content
Log in
Analog Devices MAX9710ETP-T — Analog & Data Acquisition

MAX9710ETP-T Class AB Stereo Amp, 3W x 2 @ 3Ohm

MPNMAX9710ETP-T
End of Life

Analog Devices MAX9710ETP-T Class AB stereo audio power amplifier, 2-channel, 3W x 2 @ 3Ohm, 4.5-5.5V supply, 20-TQFN exposed pad, industrial temperature.

$2.51Ref. price · indicative, final on quote
Analog Devices MAX9710ETP-T datasheet (PDF)
Packaging20-WQFN Exposed Pad
RoHSRoHS non-compliant
Sourced new & surplus through independent channelsAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

MAX9710ETP-T specifications
ParameterValue
TypeClass AB
Output type2-Channel (Stereo)
MountingSurface Mount
Voltage4.5V ~ 5.5V
Max output power x channels @ load3W x 2 @ 3Ohm
Operating temperature-40°C ~ 85°C (TA)
PackageBulk
Case20-WQFN Exposed Pad

Product details

3W per channel into 3 Ohm — the load it drives

The MAX9710ETP-T is a Class AB stereo audio power amplifier delivering 3W x 2 channels at 3 Ohm loads from a 4.5V to 5.5V single supply. That 3W figure is the continuous output into a 3-Ohm speaker — the power drops into higher-impedance loads, so the actual SPL in a portable speaker or soundbar depends on the speaker impedance chosen.

Package and rework — 20-TQFN exposed pad

Housed in a 20-TQFN 5x5 mm exposed-pad package (also listed as 20-WQFN Exposed Pad). Surface-mount only; no through-hole option. The exposed pad makes rework straightforward with hot air if you preheat the board to 100-120°C first — the part lifts clean without pulling the pad if the solder is fully liquid.

Industrial temperature range and compliance

This is a flag for EU RoHS-regulated BOMs; legacy or exempt applications may accept it, but new designs targeting full RoHS compliance should check the exemption status.

Frequently asked questions

Is MAX9710ETP-T RoHS compliant?

No — the part is listed as RoHS non-compliant. This typically means lead-bearing solder finish or internal die-attach material. Verify the exemption status for your target market before specifying it in a new design.