Single-supply general-purpose op-amp in a SOT-23-5
The input offset voltage is rated at 1.5 mV, input bias current at 50 pA, and each channel can source or sink 50 mA. Supply current is 800 µA per amplifier.
10 MHz GBW and 10V/µs slew — signal fidelity for audio and sensor conditioning
With a 10 MHz gain-bandwidth and 10V/µs slew rate, this op-amp handles signals up to several hundred kilohertz without significant distortion. The 50 pA input bias current suits high-impedance sensor interfaces — photodiodes, piezoelectric transducers, or high-value resistor dividers — where bias current error would otherwise dominate. The 50 mA output drive is enough to directly feed a downstream ADC input or a low-power actuator.
The rail-to-rail output stage maximizes dynamic range at the lower end — critical when the headroom is only a few hundred millivolts. At 800 µA quiescent current, it is efficient enough for battery-powered equipment that is not in continuous deep sleep.