Precision instrumentation amp for harsh environments
What the slew rate and offset mean for your measurement
That is fine for DC or slowly varying signals, but it will round off edges on any waveform above a few kilohertz. The 100 µV input offset voltage sets the zero-error floor: for a 10 mV full-scale bridge output, that offset is a 1% error before gain. The 4 nA input bias current is low enough that it won't upset a 10 kΩ source impedance, but check it against your sensor's output resistance if you are running at high gain.
It is a single-channel device drawing 1.3 mA quiescent current.