The Maxim DS1233DZ-5+ is a single-channel voltage supervisor from the EconoReset family, monitoring a 5V rail with a threshold of 4.625V. When the supply drops below that level, it pulls its open-drain output low and holds it there for a minimum of 250ms after the rail recovers — enough time for most microcontrollers and SoCs to finish their power-on reset sequence. The open-drain output lets you wire-OR it with other reset sources or level-shift to a lower-voltage logic input with a pull-up resistor.
4.625V threshold — why that number matters
A 4.625V trip point is typical for 5V nominal systems where the processor or logic needs to see a valid supply before releasing reset. If your design runs from a 5V rail that sags under load (say a motor start or a radio burst), this part holds the processor in reset until the rail is back above the threshold plus the hysteresis. The 250ms timeout gives the oscillator and PLL time to stabilize before the first instruction fetch. For 3.3V or 1.8V cores, you would want a different threshold variant in the DS1233 family.
Package and temperature range for the environment
Housed in a surface-mount SOT-223-3 package (TO-261-4 equivalent), this part fits standard reflow profiles and takes up minimal board space. No AEC-Q grade is listed, so it is not qualified for under-hood or powertrain domains.