Skip to main content
Analog Devices 5962-9053501PA — Logic ICs

5962-9053501PA Op Amp, 80 MHz, 170 V/µs, -55°C to 125°C

MPN5962-9053501PA
End of Life

5962-9053501PA, General Purpose Amplifier, 1 Circuit, 80 MHz Gain Bandwidth, 170 V/µs Slew Rate, 10 V to 36 V Supply, 8-CDIP (0.300", 7.62mm), -55°C to 125°C, Through Hole.

$33.66Ref. price · indicative, final on quote
Packaging8-CDIP (0.300", 7.62mm)
RoHSNot applicable
Independent supplier — new & surplus stockAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

5962-9053501PA specifications
ParameterValue
MountingThrough Hole
Amplifier typeGeneral Purpose
Voltage - input offset400 µV
Voltage - supply span36 V
Current - supply6.2mA
Current - input bias200 nA
Current - output (Channel)80 mA
Operating temperature-55°C ~ 125°C
Gain bandwidth product80 MHz
PackageBulk
Slew rate170V/µs
Case8-CDIP (0.300\", 7.62mm)
Number of circuits1

Product details

Hermetic 8-CERDIP op amp for military temperature environments

The 5962-9053501PA: It delivers an 80 MHz gain-bandwidth product and a 170 V/µs slew rate, drawing 6.2 mA supply current from rails spanning 10 V to 36 V. This combination of speed, wide supply range, and ceramic hermetic sealing makes it a fit for avionics, satellite, missile guidance, and downhole instrumentation where board-level reliability and sealed-environment operation are non-negotiable.

The 170 V/µs slew rate and 80 MHz gain-bandwidth product together define this part as a wideband amplifier. For a procurement decision, this means the 5962-9053501PA can handle fast pulse edges and high-frequency analog signals — think radar IF stages, video distribution, or high-speed data acquisition front-ends — without slew-rate limiting distorting the waveform. The 6.2 mA supply current is moderate for this speed class; a designer budgeting power in a multi-channel system will note that the quiescent draw is fixed per channel, not scaled by output load.

Input offset and bias — the DC accuracy picture

Input offset voltage is rated at 400 µV, and input bias current at 200 nA. These are typical numbers for a general-purpose bipolar op amp of this era and speed grade — not precision-instrumentation territory, but adequate for most signal conditioning in military subsystems where the signal levels are in the tens of millivolts or higher. The 80 mA output current per channel gives enough drive to swing into a 50 Ω or 75 Ω load, common in video and RF interface circuits.

Package and mounting: hermetic through-hole for high-reliability builds

The 8-CDIP (0.300", 7.62mm) ceramic dual-in-line package with through-hole mounting is the standard footprint for MIL-spec analog ICs. The 8-CERDIP variant uses a glass-sealed ceramic body that resists moisture and outgassing — critical for sealed avionics boxes and space payloads where conformal coating alone is insufficient. The through-hole leads allow manual inspection and rework, a practical advantage in prototype and low-volume defense production runs.

Frequently asked questions

Is 5962-9053501PA a true military-grade part?

Yes. It is not a commercial or industrial-grade device.

What is the replacement for 5962-9053501PA?

The part is still Active in production, so a direct replacement is not needed at this time.