Analog Devices MAX9141EKA+T single comparator with latch, 40ns propagation delay, 1.5mV hysteresis, push-pull CMOS/TTL output, 2.7V to 5.5V supply, SOT-23-8 package, -40°C to 85°C.
| Parameter | Value |
|---|---|
| Type | with Latch |
| Output type | CMOS, Push-Pull, TTL |
| Mounting type | Surface Mount |
| Voltage - input offset | 2mV @ 5V |
| Voltage - supply, single (Dual (±)) | 2.7V ~ 5.5V |
| Current - quiescent | 320µA |
| Current - input bias | 0.32µA @ 5V |
| Operating temperature | -40°C ~ 85°C |
| Package | Tape & Reel (TR); Cut Tape (CT) |
| Hysteresis | 1.5mV |
| Case | SOT-23-8 |
| CMRR, PSRR | 81.94dB CMRR, 81.94dB PSRR |
| Number of elements | 1 |
| Propagation delay | 40ns |
Rated for -40°C to 85°C operation, this comparator is specified for outdoor telecom cabinets, factory-floor sensor interfaces, and engine-bay electronics where the ambient temperature swings beyond commercial limits. The quiescent current maxes at 320 µA, keeping the thermal budget low in densely populated boards.
The MAX9141EKA+T carries an Active lifecycle status and is ROHS3 compliant. No end-of-life notice is on record.
A comparator with latch holds the output state on a latch-enable signal, making it useful for sampled-data systems such as peak detectors, zero-crossing sampling, and overcurrent fault capture where the decision must be held for a subsequent logic read.
Yes, the output type is CMOS push-pull and TTL-compatible, so it can drive logic inputs directly without an external pull-up resistor.
The MAX9141EKA+T is a single comparator with latch in a SOT-23-8 package. The MAX9142EKA+T is a dual comparator with latch in the same package footprint. The key difference is the number of comparators per package: one versus two.