Dual 150 MHz voltage feedback amp — 600 V/µs slew rate
The MAX4016ESA+ from Analog Devices is a dual voltage-feedback amplifier with a 150 MHz -3 dB bandwidth and a 600 V/µs slew rate, packaged in an 8-SOIC. That slew rate means the output can swing 3 V in 5 ns — fast enough to preserve the edges of a 20 MHz square wave without visible rounding, so the part suits high-speed ADC drivers or pulse amplifiers where settling time matters.
Supply rails and power budget per channel
Runs on a single supply from 3.15 V to 11 V, or a split supply up to ±5.5 V. Each channel draws 5.5 mA quiescent current — two channels total 11 mA — so a 5 V rail delivers about 55 mW per op-amp. The rail-to-rail output stage swings within 50 mV of the supply rails at light load, preserving headroom in low-voltage signal chains. Input bias current is 5.4 µA and input offset voltage is 4 mV — figures that matter for DC-coupled stages but are acceptable for AC-coupled or high-speed paths where the offset is blocked by a capacitor.
8-SOIC footprint and industrial temperature range
Supplied in tube packaging — not tape-and-reel — so the part arrives in anti-static tubes of 50 or 100 units. For automated pick-and-place, the tube must be loaded into a tube feeder or the parts transferred to a tape carrier.