Maxim MAX3089ECSD+, RS-422/RS-485 transceiver, full duplex, 1/1 driver/receiver, 10 Mbps data rate, 4.75V–5.25V supply, 100 mV receiver hysteresis, 0°C–70°C, 14-SOIC.
| Parameter | Value |
|---|---|
| Type | Transceiver |
| Mounting type | Surface Mount |
| Voltage | 4.75V ~ 5.25V |
| Protocol | RS422, RS485 |
| Operating temperature | 0°C ~ 70°C |
| Duplex | Full |
| Package | Tube |
| Data rate | 10Mbps |
| Case | 14-SOIC (0.154\", 3.90mm Width) |
| Receiver hysteresis | 100 mV |
| Number of drivers (Receivers) | 1/1 |
Full-duplex operation means the driver and receiver are active simultaneously. That requires four wires on the bus (two for transmit, two for receive) but eliminates the turnaround delay that half-duplex parts need when switching direction. If your protocol is full-duplex at the controller, this transceiver matches the bus architecture directly.
The MAX3089ECSD+ is listed as Active on Maxim's lifecycle.
No. The supply range is 4.75 V to 5.25 V — a 5 V rail only. A 3.3 V supply is below the minimum, so this part is not suitable for 3.3 V buses without a level translator.
The listed type is Transceiver, and the duplex is Full, meaning one driver and one receiver can operate simultaneously on a four-wire RS-422 or RS-485 bus.