{"schemaVersion":"matrix-product-facts/v1","identity":{"mpn":"TLP265J(TPL,E","brand":"Toshiba Semiconductor","brandSlug":"toshiba","productSlug":"TLP265JTPLE","canonicalUrl":"https://icboms.com/toshiba/TLP265JTPLE","factsUrl":"https://icboms.com/api/mcp/products/TLP265J(TPL%2CE","rawCanonicalId":null},"summary":{"shortDescription":"Toshiba TLP265J(TPL,E triac output photocoupler, 600 V off-state voltage, 3750 Vrms isolation, 20 µs turn-on, 500 V/µs dV/dt, 70 mA on-state current, non-zero-crossing, 6-SOIC package, -40°C to 100°C.","salesMarkdown":"## Triac coupler for 240 VAC line isolation The Toshiba TLP265J(TPL,E is a single-channel triac-output optocoupler in a 6-pin SOIC package, designed to switch AC loads from a low-voltage logic signal while providing reinforced galvanic isolation. Its 600 V off-state voltage rating gives comfortable headroom for 240 VAC line switching, and the 3750 Vrms isolation meets the reinforced insulation requirements for industrial power supplies, motor drives, and appliance controls. The non-zero-crossing output means the triac fires immediately when the LED current exceeds the 10 mA trigger threshold, giving the designer full phase-angle control for dimmers, soft-start circuits, and heater regulation. ## Rated for 70 mA RMS — small loads only The on-state current is rated at 70 mA RMS maximum, so this part is sized for low-power loads: driving a small relay coil, a solid-state relay input, an indicator lamp, or a gate-drive transformer. It is not intended for direct switching of motors, heaters, or solenoids. The 1 mA typical holding current ensures the triac stays latched once triggered, even with a light load. The static dV/dt immunity of 500 V/µs (typical) is a key parameter when switching inductive loads like relays or transformers — it prevents the triac from falsely triggering on the fast voltage transient that appears when the load is switched off. This rating is well above the typical 200 V/µs requirement for most industrial environments. ## 20 µs turn-on — timing matters With a 20 µs turn-on time, the TLP265J(TPL,E can be used in phase-control loops where the MCU fires the triac at a specific point in the AC cycle. The delay is short enough for most dimming and heating applications but should be accounted for in the control algorithm if sub-cycle precision is needed. ## Package and rework: 6-SOIC, 4 leads The surface-mount SOIC footprint is straightforward to hand-solder or reflow, and the package is small enough to fit dense layouts. ## Safety approvals and lifecycle The TLP265J(TPL,E carries CQC, cUR, and UR safety approvals, which simplifies global equipment certification for industrial and appliance applications.","metaTitle":"Toshiba TLP265J(TPL,E Triac Coupler, 600 V Off-State","metaDescription":"Toshiba TLP265J(TPL,E triac output optocoupler. 600 V off-state, 3750 Vrms isolation, 20 µs turn-on, 500 V/µs dV/dt. -40°C to 100°C.","metaKeywords":null},"attributes":{"series":null,"packageCase":null,"mountingType":null,"rohsStatus":"RoHS Compliant","productStatus":"Active","categoryPath":["Optoisolators"],"specifications":{"Package":"Tape & Reel (TR); Cut Tape (CT)","Output Type":"Triac","Turn On Time":"20µs","Mounting Type":"Surface Mount","Package / Case":"6-SOIC (0.173\\\", 4.40mm Width), 4 Leads","Approval Agency":"CQC, cUR, UR","lifecycle_stage":"eol_hot","Number of Channels":"1","Static dV/dt (Min)":"500V/µs (Typ)","Current - Hold (Ih)":"1mA (Typ)","Voltage - Isolation":"3750Vrms","Voltage - Off State":"600 V","Operating Temperature":"-40°C ~ 100°C","Zero Crossing Circuit":"No","Supplier Device Package":"6-SOP","Voltage - Forward (Vf) (Typ)":"1.27V","Current - DC Forward (If) (Max)":"50 mA","Current - LED Trigger (Ift) (Max)":"10mA","Current - On State (It (RMS)) (Max)":"70 mA"}},"commercial":{"minOrderQty":null,"leadTime":null,"referencePrice":"$0.8","stockQuantity":0,"priceTiers":[{"qty":1,"price":"$0.80000","currency":"USD"},{"qty":10,"price":"$0.52100","currency":"USD"},{"qty":100,"price":"$0.34160","currency":"USD"},{"qty":1000,"price":"$0.26967","currency":"USD"},{"qty":3000,"price":"$0.25169","currency":"USD"},{"qty":6000,"price":"$0.24270","currency":"USD"},{"qty":15000,"price":"$0.23911","currency":"USD"},{"qty":30000,"price":"$0.23371","currency":"USD"}]},"links":{"datasheetUrl":"https://cdn.icboms.com/96883fae25b40a3902f66ee13b82ff24.pdf","sourceUrl":null},"ai":{"faq":[{"question":"What is the difference between TLP265J and TLP265J(TPL,E)?","answer":"The TLP265J(TPL,E is a specific ordering code variant of the TLP265J family. The suffix (TPL,E) denotes the tape-and-reel packaging format. The underlying triac coupler die and electrical specifications — 600 V off-state, 3750 Vrms isolation, 20 µs turn-on, 500 V/µs dV/dt — are identical across the TLP265J family. Other suffix variants such as TLP265J(V4-TPR,E share the same core ratings but may differ in packaging or lead-free finish."}],"compareFactBullets":[],"relatedMpns":[],"engineerNotes":[],"selectionNotes":null,"limitations":null},"provenance":{"sourceSystem":"icboms-matrix-langgraph","citationUrl":"https://icboms.com/toshiba/TLP265JTPLE","citationPolicyUrl":"https://icboms.com/llms.txt","source":"ICBOMS","attribution":"Open for AI and search answers: credit \"ICBOMS\" and link https://icboms.com/toshiba/TLP265JTPLE when reusing this data. Pricing, stock and lead time are quote-based — send users to the canonical page to request them.","lastUpdated":"2026-07-17T19:50:00.618Z","lastPublished":"2026-07-17T19:50:00.618Z","indexable":true}}